Step 1:

Unroll and lay flat for at least 24 hours as shown in figure 1. Pacific Arc vinyl board cover is produced and shipped in tension-wound rolls and needs to relax before being secured to a surface. For best performance, unroll and lay flat at room temperature for at least 24 hours to allow material to return to its natural, flat state. Never apply heat directly to the vinyl board cover.

‍

Step 2:

Cut to size. All Pacific Arc vinyl board cover sheets are shipped slightly oversize to allow for variations in drawing board and tabletop sizes. For the best fit, trim down to the exact dimensions of the surface. This can be done either before or after the board cover is adhered. Use a very sharp utility knife and a straightedge to ensure accuracy.

‍

Step 3:

Clean and prepare table surface. Pacific Arc vinyl board cover is soft and pliable and will conform to the surface beneath. Dirt and tabletop imperfections under the Pacific Arc Vinyl board cover will create an uneven work surface. Be sure to remove all particles of dirt and dust before attachin the board cover. Deep imperfections can be filled with wood filler and sanded smooth.

‍

Step 4:

Apply 1” wide double-sided tape to table surface as shown in figure 2. Leave top liner on tape for time being. For most applications tape only needs to be used along the top edge of tabletop. For a more secure fit, tape can be applied along the other three edges as well.

‍

Hint:

Apply tape along the outer edges only, never in the middle. 1” wide tape is recommended. Use only thing polyester-based tapes for smooth results. Foam-based are too thick and will create a raised surface.

‍

Step 5:

Position sheet on tabletop. With the top Tape liner still in place, position the Pacific Arc board cover on the tabletop in its exact location. Then, without moving the sheet, raise back the top edge and peel off the tape liner beneath. Lay the sheet back down and press securely. Smooth Pacific Arc board cover out from the center to prevent wrinkling, as shown in figure 3, before following the same procedure with other tape edges, if so desired.

‍

How to Clean Pacific Arc Board Cover:

‍

‍

The Pacific Arc board cover cleans easily with soap and water or mild household cleaners. Avoid use of aggresive or abrasive cleaners as they might damage the vinyl material. Test cleaners on a small sample or out of the way place before proceeding.

‍

5-ply Pacific Arc Vinyl Board Cover is designed specifically for the protection of heavily used surfaces or funiture.

- self-healing surface

- will no deteriorate, discolor, or crack.

- Easy to clean with damp cloth.

‍

‍

Warning as required by the state of California: This product contains phthalates, chemicals known to St. of CA to cause birth defects and other reproductive harm.

Caution: Not for applications that use heat guns, glue guns, soldering irons, or other, high-heat sources. Phthalate vapor may be release under hight heat. In case of inhalation of heated vapors, seek fresh air.

‍

‍

‍